Līmēšanas Java Siltumizolācijas Plāksnēm Caparol Capatect Rollkleber 615 25kg (33962)

Field of Application
Adhesive compound for full-surface bonding of Capatect EPS insulation boards and Capatect MW insulation boards to board materials in wooden structures. Especially suitable on organically bonded wood-based panels according to DIN EN 13986 and DIN 20000-1 and other load-bearing and even, slightly absorbent substrates such as flat pressed boards, gypsum fibre boards and fibre cement boards approved by the building authorities.

Material Properties
High adhesive strength
Excellent adhesion to many substrates

Colours
Natural white

Substrate Preparation
The substrate must be flat and free of misalignment, as leveling with the adhesive is only possible to a very limited extent.
The substrate must be free of dust and release agents, dry and have a proven load-bearing capacity. The suitability of some substrates must be checked before application. For this purpose, tear-off tests must be carried out on the panel material.

Preparation of Material
"Capatect Rollkleber 615" is ready to use for trowel application without further additives. It only needs to be stirred briefly with a slow-running agitator. If necessary, adjust the consistency with a little water.
When applying with a lambskin roller (preferably long-pile), adjust the consistency if necessary by adding 3.5 - 4 % water.

Consumption
Depending on the application method (depending on the application thickness and the evenness of the substrate).
Toothed trowel application: approx. 2.0 - 2.5 kg/m2
Roller application: approx. 2.0 kg/m2
Determine exact material requirements by trial coating on the object.

Application Conditions
During The application and in the drying phase, the ambient and substrate temperatures must not be below +5 °C and above +30 °C.
Do not apply in direct sunlight, strong wind, fog or high humidity. In this context, we refer to the leaflet "Verputzen, Wärmedämmen, Spachteln, Beschichten bei hohen und tiefen Temperaturen" (Plastering, Thermal Insulation, Filling, Coating at High and Low Temperatures) from the Bundesverband Ausbau und Fassade (Federal Association for Finishing and Facades).

Drying/Drying Time
Depending on the absorbency of the board materials, the application quantity of the adhesive and the ambient conditions.
At 20 °C and 65 % relative humidity, approx. 72 hours depending on the application thickness.
At lower temperatures and higher humidity, these times are extended accordingly.
With additional mechanical fastening, further processing is also possible earlier.

Tool Cleaning
Immediately after use with water