Armēšanas Java Caparol Capatect-ZF-Spachtel 699 Stūru Profilu Montāžai 20kg (923119)

Field of Application
Reinforcement compound for use within the Capatect ETICS System B. Surfacer for plaster renovation. Suitable for mounting edge profiles.

Material Properties

• Ready-to-use and easy to apply
• Excellent adhesion
• Good fresh mortar stability
• Low shrink tension
• Water dilutable
• Water repellent

Substrate Preparation
Abrade all surface irregularities and offset at butt joints of EPS boards to achieve an even surface. Remove adherent abraded dust. Protect window sills and other attached parts.
All substrates must be load-bearing, dry, even (DIN 18202 or 18203), clean and free of adhesion-reducing residues.

Preparation of Material
The material is ready to use. Stir up shortly before application.
Adjust to working consistency with a very small amount of tap water, only if necessary.

Method of Application
Apply Capatect ZF-Spachtel 699 onto the front side of the thermal insulation boards in the width of the reinforcing fabric stripe "Capatect-Gewebe 650/110". Embed the reinforcing fabric thoroughly - stripe by stripe - into the freshly applied and still wet surface with an overlap of approx. 10 cm. A subsequent coat of Capatect 699 must be immediately applied (wet-on-wet), to guarantee a complete embedding of the fabric and a total reinforcement layer thickness of approx. 2-3 mm. A layer thickness up to 5 mm is possible. The reinforcing fabric should be embedded in the center of the layer. For layer thickness ≥ 4mm it is best placed in the outer third of the reinforcement layer - but it must be well covered.
Note: To achieve an uniformly flat surface of Capatect ZF-Spachtel 699 on mineral wool boards apply first a 1 - 2 mm thick base coat of Capatect ZF-Spachtel without fabric to stabilize the surface of the mineral wool. After curing apply a second coat of Capatect ZF-Spachtel 699 and embed the Capatect-Gewebe 650/110 into this coat.