Armēšanas Java Caparol CarboNit Ūdens Noturīga Ar Oglekļa Šķiedrām 22kg (814006)

Highly impact-resistant, carbon fibre reinforced and water-resistant 2-component reinforcing compound for use in the area of plinth

Field of Application
Shock and impact-sensitive walls, for example at doorways, in plinth area or along dustbin spaces.

Material Properties
2-component carbon fibre reinforced,highly impact-resistant reinforcing compound for generating a two-layered reinforced rendering in the area of plinth walls.
Thickness: total min. 8 [mm]; 1st layer min. 5 [mm]; 2nd layer min. 3 [mm].

Suitable for use in the area of splashing water due to a water repellant formulation, optimised especially for the area of plinths.

Material Base / Vehicle
Synthetic resin emulsion with filler of calcium aluminates, calcium silicates and magnesium oxide.

Substrate Preparation
Before the installation of perimeter insulation the building needs a protection against soil moisture according to the local situation.

Necessary drainage will not be replaced by a perimeter insulation with Carbonite reinforcement.

Other Capatect EPS thermal insulating-boards may be used in the visible plinth area.

Preparation of Material
Add the PowerPowder component into the liquid component by stiring intensively with a low-speed electrical paddle (agitator; max. 400 rpm) until a homogeneous material, free of lumps, is achieved. The quantity of both components is exactly matched; do not add any other additives.

Mixed material has a pot life of approx. 30 minutes (at 20 ° C). Higher temperatures shorten and lower temperatures extend the pot life.

Method of Application
CarboNit is applied in two layers.
Apply the first layer of CarboNit with a notched trowel in the width of reinforcing fabric sheets. Embed the Capatect-Gewebe 650/110 (reinforcing fabric) thoroughly into the freshly applied layer with an overlap of min. 10 cm along joint areas.

Subsequently apply again CarboNit, wet-on-wet, to guarantee complete cover/
embedding of the fabric sheets. The reinforcing fabric must be embedded in the upper third of the reinforcement layer.
Minimum thickness of the first reinforcement layer in total: 5 mm.

Allow to dry for approx. 24 hours (depending on climatic conditions) and apply a second layer of reinforced CarboNit in the same way than before. The reinforcing fabric must be embedded in the middle.
Minimum thickness of the second reinforced layer: 3 mm.