Gatavais Silikona Tonējamais Dekoratīvais Apmetums Caparol CT Amphisilan FassadenPutz K20 Transp Base 3 (Biezpiens) 25kg (980785)

Ready-to-use, structurable silicone resin finishing coat as per DIN EN 15824

Ready-to-use, structurable silicone resin finishing coat for mineral and organic wall and ceiling surfaces outdoors. Can be used in conjunction with the Capatect facade systems.

Material Properties

• Highly water vapour permeable
• Water-repellent
• Elegant application
• Water-dilutable
• Increased protection against fungal and algae infestation
• Balanced filler-aggregate combination with non-fading pigments

Gloss Level
Matt

Storage
Cool, dry, frost-free and protected from direct sunlight.

Diffusion-equivalent air layer thickness sdH2O
< 0.14 m according to DIN ISO 7783
Class V1 (high) as per DIN EN 15824

Adesive tensile strength
≥ 0.3 MPa as per DIN EN 15824

Fire behaviour
A2-s1, d0 as per DIN EN 13501-1 (non-combustible)

Binding agent
silicone resin

Water permeability (w-value)
≤ 0.1 kg/(m2·h0,5) as per DIN EN 1062-3
Klasse W3 (low) as per DIN EN 15824

Substrate Preparation
The substrate must be even, clean, dry, solid, sound/ stable and free from all substances that may prevent good adhesion. In Germany follow VOB, part C, DIN 18 363, section 3.

Remove unsound coatings of enamel, emulsion paint, synthetic (organic) render/ plaster and unsound mineral paint coatings completely. Clean adherent paint coatings dry or wet.

Clean surfaces infested with organic growth (fungi/ mildew/ mould, moss, algae attack) with a high-pressure water jet, in compliance with the regulations. Then use Capatox and allow to dry thoroughly. Clean surfaces contaminated with industrial pollution (factory fumes) or soot by high-pressure cleaner and suitable cleaning agent, in compliance with the regulations.

Preparation of Material
Stir Capatect AmphiSilan Fassadenputz thoroughly with a low-speed stainless steel agitator. If necessary adjust to working consistency with tap water, max. 1 % if manually applied and max. 2 % for spray application.

Method of Application
Apply all textured render with a stainless steel trowel or suitable spraying equipment homogeneously to surface sections. Rub off immediately to the grain size and take off excessive slurry. Treat the K-type render evenly with a plastic trowel or PU-board by circularly "ironing". Groove the R-type render horizontally, vertically or circularly with a plastic trowel as desired.
The surface roughness is influenced by the chosen tool, hence always the same type of texturing tool should be used.

For spray application the nozzle size depends on the grain size (nozzle size = 4 x grain size).
Working pressure: 0.3 to 0.4 MPa (3 to 4 bar). Apply thoroughly an homogeneous layer during spray application. Avoid visible overlapping that may be caused by storeys of scaffolding.

Always the same craftsmen should finish seamless surfaces to achieve an even texture. To avoid lapping on large-area surfaces, care should be taken to have a sufficient number of craftsmen on the job and to apply the material wet-on-wet without interruption.
Granules and filler are natural products and therefore may occasionally cause slight colour variation in the finished coating. Only use products of the same batch or, if materials from different batches must be applied, mix the entire quantity needed in advance.

Capatect AmphiSilan Fassadenputz is not suitable for horizontal surfaces exposed to water.