Sakret NSP+ Self levelling floor 25kg

Sakret NSP rapid-setting self-leveling compound for floors is a fast-drying, self-leveling compound (3-20mm). It can be used on heated floors, concrete surfaces. Rapid setting (10mm/24h); Smooth surface leveling; Before applying finishing coverings (carpet, linoleum, parquet, laminate, etc.); Layer thickness 3-20mm in one layer; Full and partial leveling of horizontal surfaces; Can be applied manually and mechanically; Wear class - A12; Cement-based; Non-combustible.

Consumption: 1.6 kg/m2 (in a 1mm thick layer)

Application:

• The substrate must be dry and firm, all cracks and voids must be filled
• Clean the substrate from less durable and/or detachable layers
• Prime absorbent surfaces with SAKRET UG primer (diluted 1:2)
• Dry and highly absorbent surfaces should be primed twice!
• The compound can be used on concrete and other mineral substrates
• It is forbidden to use SAKRET NSP on gypsum or anhydrite substrates!
• When using SAKRET NSP on heated floors, the heating must be turned off 5 days before and must not be turned on for 28 days after the material is applied!
• Mix SAKRET NSP in a clean container with cold water until a homogeneous mass without lumps is formed
• It is recommended to use a mixer with 600 revolutions per minute
• After the setting time (~3 minutes), mix again
• Do not dilute the started material with water, but mix again with a mixer
• Pour the compound onto the surface (layer thickness >3mm) and level with a spiked roller
• Do not fill expansion joints with the leveling compound
• When leveling the substrate, an amortizing material must be installed around the perimeter
• When using the material for large volume floor leveling, the intervals of floor expansion joints must be observed
• Technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher temperature decreases the specified values
• Protect the leveling compound during the hardening phase from sunlight, drafts, frost, and excessively high temperatures (>25°C)
• Hardened compound can only be removed mechanically
• Contains cement, reacts alkaline
• Protect skin and eyes, follow the technical instructions. If the material gets into the eyes, rinse with plenty of water and, if necessary, seek medical attention
• Protect the packaging from the influence of weather conditions, store on wooden pallets, in a cool and dry place, immediately cover any opened packaging

Technical data: