SAKRET Elastic tile glue gray C2TE Fke 25kg

Sakret Elastic Tile Adhesive Gray C2TE Fke - Tile adhesive for applying thin and medium thick layers on cement-based surfaces, ceramic tiles and slabs, facade cladding slabs, concrete slabs, mosaics, stone masses, fireplace tiles. Suitable for bonding tiles to concrete, old tiles, and other mineral substrates, as well as to gypsum board, fiberboard, and cement board. Suitable for both indoor and outdoor use. Suitable for underfloor heating. Can also be used for tiling over old tiles.

Consumption: Approximately 2.4 kg/m² of dry mixture, if the notch size is 6 mm

• for indoor and outdoor use
• frost and moisture resistant
• for walls and floors
• for underfloor heating
• for tiling on gypsum board
• for tiling directly on old tiles
• for tiling on waterproofing membranes
• on cement-based surfaces
• for bonding in thin and medium thick layers
• for glass mosaic
• in gray color
• class C2TE
• for ceramic, stone mass, stone cladding slabs, mosaic tiles, fireplace cladding tiles, clinker tiles and slabs

Surface preparation:

• the substrate must be firm, dry, durable, and free of cracks;
• clean the substrate from less durable and/or detachable layers (e.g. dirt, dust, oil, paint residues, etc.);
• especially dense and/or smooth substrates should be scraped;
• prime the substrate with SAKRET UG primer. For concrete, gypsum board, and other mineral substrates, dilute it with water in a ratio of 1:2, but use undiluted SAKRET UG primer for fiberboard and cement board.

Application:

• mix SAKRET FKe in a clean container with cold water until a homogeneous mass without lumps is formed;
• it is recommended to use a mixer with 600 revolutions per minute;
• after the maturing time of approximately 3 minutes, mix again;
• do not dilute material that has started to harden with water!
• apply only as much mortar as can be tiled in approximately 20 minutes;
• do not fill expansion joints with adhesive!

Technical data: