Weber Handy Fix tile adhesive 25kg

Especially flexible tile adhesive weber handy fix Tile adhesive for interior and exterior work - in wet and dry rooms, on terraces and balconies. Suitable for stable horizontal and vertical mineral substrates, plasterboard, waterproofing and heated floors. Used for bonding stone mass and ceramic tiles. For clinker, mosaic and large format tiles, Weber recommends the elastic tile adhesive Weber Easy Fix, for pools - Weber.vetonit RF. Consumption is approximately 3 kg/m².

Positive properties:

• Meets C2T (EN 12004) class requirements• Suitable for surfaces with high loads

Application:

• The substrate to be tiled must be stable, leveled and free from substances that weaken adhesion: debris, dust and oils. The temperature of the substrate and air during application and 2 days after application must be above +5OC. It is advisable to lightly moisten or prime concrete and other absorbent substrates with Weber SAD-54 deep primer (priming of substrates before Weber waterproofing is mandatory). For heated floors, it is recommended to raise the temperature to the maximum for a few hours, then turn off the heating and let the floor cool for one day.• Dry mix should be mixed only with clean water. Do not add more water than indicated - it reduces the adhesive properties. Mixing should be done with a mixer for 3-5 minutes until a workable, homogeneous mass without lumps is obtained. Then let the mixture stand for about 10 minutes for the substances in the composition to react fully with water and the adhesive to obtain the appropriate consistency. Before starting the bonding, lightly mix the mixture again. It is recommended to mix the amount of tile adhesive that can be used within 4 hours at the same time.• The adhesive mortar should be applied to the substrate to be tiled in a layer 2-8 mm thick using a smooth trowel or spatula. During application, the mixture should be pressed to ensure better penetration into the substrate and provide the best possible adhesion. Then the applied layer should be smoothed with a notched trowel. At the same time, lay and smooth an area that can be covered with tiles within 10-15 minutes. Start laying the tiles one by one on the covered substrate. After placing each tile, press it firmly in different directions to ensure a tight bond. As a result, at least 80% of the back of the ceramic wall tiles should be covered with adhesive, but in other cases, the backs of the tiles should be fully covered. To check the adhesion of the tiles to the substrate, occasionally remove and replace one of the applied tiles, checking how it sticks back. The tile layout can be adjusted within 20 minutes after attachment. The adhesive in the joints should not rise higher than half the depth of the joint. Excess mortar should be immediately cleaned with a damp cloth. Tile spacers and other fixing tools should be removed when the adhesive hardens. Tools should be washed with water immediately after work. It is allowed to lightly walk on the tiled floor after 1 day.• Joint sealing can be done after 2-3 days. For joints 1-8 mm wide, Weber recommends 30 color options of elastic tile grout Weber.vetonit DECO and silicone sealants Weber.color. Underfloor heating systems should be turned on gradually and no earlier than a week after grouting.