Sakret FFK Tile Adhesive with Improved Properties, Grey C2TE S1 25kg

Sakret Super elastic tile adhesive C2TE S1 FFK - Adhesive for applying thin and medium thick layers on cement-based surfaces, suitable for bonding ceramic and concrete finish tiles, ceramic, mosaic and stone mass tiles (excluding marble tiles). Suitable for bonding on concrete and other mineral surfaces, as well as on old tiles, gypsum board and fiberboard. For pools and water reservoirs. Suitable for underfloor heating and fireplace cladding.

Consumption: approximately 2.6 kg/m2 of dry mixture, if the tooth size is 6 mm

Super elastic tile adhesive

• for interior and exterior work
• frost and moisture resistant
• for walls and floors
• for underfloor heating
• for tiling on gypsum board
• for tiling directly on old tiles
• for tiling on waterproofing membranes
• for facade tile bonding in insulation systems
• for bonding on wood surfaces
• on wood fiber boards and plywood
• for bonding in thin and medium thick layers
• suitable for thermal walls and fireplaces
• operating temperature -25°C to 80°C
• in gray color
• for ceramic, stone mass, stone finish tiles, mosaic tiles, fireplace cladding tiles, clinker tiles and panels

Surface preparation:

• The substrate must be firm, dry, durable and free of cracks.
• Clean the substrate from less durable and/or detachable layers (e.g. dirt, dust, oil, paint residues, etc.).
• Especially dense and/or smooth substrates should be scraped.
• Prime the substrate with SAKRET UG primer. For concrete, gypsum board and other mineral substrates, dilute it with water in a ratio of 1:2, and for fiberboard and fiberboard panels, use undiluted SAKRET UG primer.

Application:

• Mix SAKRET FFK in a clean container with cold water until a homogeneous mass without lumps is formed.
• It is recommended to use a mixer with 600 revolutions per minute.
• After the maturing time, approximately 3 minutes, mix again.
• Do not dilute material that has started to harden with water!
• Apply only as much mortar as can be tiled in approximately 20 minutes.
• Do not fill expansion joints with adhesive!

Instructions:

• Technical data refers to a temperature of 23±2°C and a relative air humidity of 50±5%. Lower temperatures increase, higher temperatures decrease the given values.
• Protect SAKRET FFK from sunlight, drafts, frost and excessively high temperatures (>+25°C) during the hardening phase.
• Contains cement, reacts alkaline with moisture!
• Contains soluble hexavalent chromium Cr(VI) ions ≤ 0.0002%.
• The letters after the date indicate the manufacturer: EST - OÜ SAKRET; LV - SIA SAKRET; LT - UAB SAKRET LT.

Technical data: Water addition for 25 kg: approximately 6.7 liters Maturing time: approximately 3 minutes Working time: approximately 2 hours Processing temperature: from +5°C to +25°C Can be walked on and joints can be filled after: approximately 24 hours Fully loaded: after approximately 14 days Consumption: approximately 1.8 kg/m2 of dry mixture, if the tooth size is 4 mm approximately 2.6 kg/m2 of dry mixture, if the tooth size is 6 mm approximately 4.4 kg/m2 of dry mixture, if the tooth size is 10 mm Storage:

• Protect from weather conditions, store on wooden pallets in a cool and dry place, immediately cover opened packaging.
• Shelf life - 12 months in original packaging.