Reverse Osmosis Filter Cartridge Set with Mineralization for Geyser Prestige and Prestige P (50090)

The GEYSER cartridge set RO 1 is intended for replacing cartridges that have exhausted their resources in stationary osmosis filters manufactured by the company "GEYSER" or other 10"SL (Slim Line) standard manufacturers. They are used in regions with hard water.

1. DELIVERY KIT
1. PP cartridge 1 pc.
2. CBC cartridge 2 pcs.
3. Osmosis membrane 1 pc.
4. Carbon post-filter 1 pc.
5. Instructions for use 1 pc.
6. Packaging 1 pc.

2. ORDER OF REPLACEMENT OF CARTRIDGES IN THE FILTER

Cartridges are replaced in the following order:

1. The PP cartridge is installed in the first housing.

Cleans mechanical particles from water - rust, sand and other undissolved particles larger than 5 µm.

Made of special structure foam polypropylene - the fiber density in the cartridge gradually increases from the outer surface to the inner one. As a result, the largest particles are eliminated first, then the smaller ones. Thus, a more complete use of the entire filter material is achieved. Therefore, PP cartridges are more efficient and have a greater resource than cartridges with a homogeneous porous structure.

2. The CBC cartridge is installed in the second and third housings.

CBC - a cartridge of pressed activated carbon, manufactured according to the "carbon block" technology. Made only from natural sorbent - high-quality activated carbon. Thanks to the porosity of 10 microns, the water is purified from mechanical particles. The CBC cartridge effectively removes chlorine, organic and organochlorine impurities, pesticides, petroleum products, phenol, Cryrtosporidium and Griardia bacteria. In the course of filtration, the taste, color and smell of water are qualitatively improved.

Cartridges made according to carbon-block technology have a higher sorption capacity and resistance to bacterial growth than ordinary granular carbon. The high quality and efficiency of the CBC cartridge is confirmed by the NSF certificate (issued by the most authoritative independent international organization that certifies goods and services in the field of health protection).

The membrane ULP1812-50 GPD Vontron is installed in the membrane housing.

Designed to effectively separate various small microorganisms, hardness salts, chlorine, iron and other dissolved impurities (up to 0.0001 µm) from water. Filtration efficiency is at least 98%. Filtration speed 200 l/day. The filtering material consists of a roll-shaped reverse osmosis membrane.

4. Carbon post-filter ILB-GAC-1/4

Removes the aftertaste and odor of water that has been passed through the reverse osmosis membrane and stored in the water filter tower.

REPLACEMENT OF STAGE I, II, III CARTRIDGES

Close the tap in the inlet and in the storage tank. Open the clean water tap to reduce the pressure in the system. Remove the filter housing flask (1) with a wrench and replace the corresponding cartridge. Before reinstalling, coat the O-ring with food-grade silicone (not to be confused with sealant!) or petroleum jelly. Install the flask and tighten with a wrench. Check the tightness of the system.

Reverse osmosis membrane replacement

To ensure the safety of the membrane during transport and storage, it is delivered hermetically sealed. Before installation, remove the packaging, close the beacon and water supply taps, open the clean water tap and disconnect the housing connection pipes (1). Remove the old membrane (2). Install the new membrane, grease the seals with food-grade silicone or petroleum jelly (3). Screw the cover of the membrane housing. Use only recommended membranes for replacement.
Replacement of carbon after filter and mineralizer
Disconnect the housing tubes (1), replace the afterfilter with a new one, connect the tubes. Replacement of the mineralizer is done analogously.
Note. Do not mix up the water inlet and outlet of the afterfilter. The direction of water flow is shown by an arrow on the post-filter housing.