Nocchi FP14KVX Submersible Water Pump 0.6kW (111072)

The submersible pump is designed for pumping drainage water. It is allowed to pump water with a small amount of solid particles up to 6mm in diameter, which are not abrasive. The pump can be used for small suction work, such as removing water from flooded basements, small waterlogging works, pumping rainwater, operating small garden fountains, and maintaining small swimming pools.

Usage restrictions:
1. The temperature of the pumped water must not exceed +35°C.
2. It is forbidden to pump water with mud, sand, or other abrasive particles, as well as oil-containing and chemically aggressive fluids.
3. Not intended for watering gardens.

Installation:

1) The pump must be placed on the floor of the suction tank or hung above the sediment layer several centimeters above the handle.
2) The pump should be placed so that the float-type gravity valve can move freely in the vertical direction.
3) The maximum allowable immersion depth of the pump below the water level is up to 5 meters.

Connection of the hose:

The water supply hose can be connected to the pump:
1. Using the outlet with a "little tree" (included in the package), attaching the hose with an internal diameter of 32mm to it and tightening it with a clamp.
2. Using the external thread 1"1/4 on the pump body, to which a transition to a smaller diameter tube is screwed (not included in the package).

Choosing the hose:

Use a hose that retains its shape and is open along its entire length. A soft hose that has become flat or has closed folds can create such resistance to water flow that the pump cannot open it. Use Aliflex hose with a diameter of Ø32. It is not recommended to use hoses with a diameter smaller than 19mm.

Adjusting the gravity valve:

The gravity valve turns the pump on and off automatically depending on the water level. To fix it, there is a hook on the side of the pump handle. The cable of the gravity valve is placed in this hook. The length of the cable must be adjusted so that when the gravity valve is in the lower position, the pump is guaranteed to be disconnected from the power supply.

Operation:

1. The pump must be completely submerged in water during operation.
2. The pump does not require any lubrication or pre-wetting of the housing with water. It is ready for operation immediately after being submerged in water.
3. The pump is turned on and off by the gravity valve as the water level rises or falls.

Air vent valve:

To ensure better cooling of the pump motor, there is an empty space between the stator and the stainless steel casing of the pump, through which the pumped water flows. In the upper part of the pump, under the handle, there is an air vent valve through which air is automatically released from this space.

Materials:

The lower part of the pump body, suction flange, impeller, and filter are made of technopolymer. The motor shaft and the casing of the pump are made of stainless steel. The engine is separated from the pump chamber by a special double mechanical seal. The rotor shaft is equipped with self-lubricating sealed ball bearings that do not require any maintenance.