Weber Floor Base 10 Self-Leveling Concrete for Floors

Weber (Vetonit) dry concrete for floor bases 10 - For the construction of cement floors indoors and in basements, as well as on terraces and balconies. Can be used with underfloor heating systems. Resistant to moisture. Can be applied manually or mechanically. Strength: 20 Mpa. Suitable for concrete, stone/ceramic tiles, polystyrene, and mineral fiber insulation boards. Industrially prepared mixture - ready for application by adding water. Quick and easy to apply.

Application:

• The substrate to be treated must be dry and free from substances that weaken adhesion: debris, dust, and oils. The temperature of the substrate and air during application and for a week after application must be above +10°C. The substrate must be primed with Weber.vetonit MD16. • The dry mixture should only be mixed with clean water. Do not add more water than indicated - this reduces the adhesive properties of the material. Mixing should be done with a mixer for 3-5 minutes until a workable, homogeneous mass without lumps is obtained. Then let the mixture stand for about 5 minutes and mix lightly again. • Weber.floor BASE 10 is applied in a layer 10-80 mm thick using a trowel. The thickness of the layer for heated floors should be no less than 40 mm, on insulation boards - 30 mm. During application and for one day after application, avoid drafts. • To prevent cracks due to rapid moisture release, it is advisable to cover the surface immediately after application with polyethylene film or a tarpaulin and moisten it for 2 days. • The surface can be walked on after 6 hours (at +20°C). The next layer can be applied or the final floor covering can be installed after 1-3 days. When installing the final floor covering, consider the moisture parameters indicated by the manufacturer.