FINNFOAM XPS Extruded Polystyrene foam insulation (grooved)

FINNFOAM Extruded polystyrene FL300PX with embossed surface - When insulating building structures, it is crucial for the thermal insulation material to adhere well to the insulated surface. Equally important is for the sheet to have good adhesion with the reinforcement and decorative plaster layer. Finnfoam offers the use of sheets with a grooved surface. Sheets with a waffle-like surface have better adhesion properties with the insulated surface or plaster. Insulation masters will truly appreciate these advantages. Thanks to the grooved surface, Finnfoam XX sheets are ideal for insulating plinths, beams, walls, and other plastered structures. Possible sheet sizes: 600 x 1250 mm, thickness - 20, 30, 50, 80, 100, 120 mm. Finnfoam XX sheets are used for insulating plinths, beams, thermal bridges, walls, and other structures that require good adhesion with the bonding surface or plaster.

Advantages of Finnfoam XX boards:

• Provides effective thermal insulation
• Low water absorption
• Resistance to compression (strength)
• Properties are not affected by changes in conditions
• Resistant to freezing and thawing cycles
• Long-lasting
• Does not release harmful gases or particles
• Easy to use
• Produced while protecting the environment
• 100% recyclable

Extruded polystyrene Finnfoam XX sheets are lightweight and easy to install, easy to cut using simple tools. When gluing Finnfoam XX sheets, it is recommended to use cold bitumen adhesive without solvents, polyurethane (PU) adhesive, or cement-based adhesive. The instructions of adhesive manufacturers should provide information on the possibilities of gluing polystyrene sheets. Finnfoam XX sheets have a grooved surface, so the surface does not need to be mechanically treated to make it rougher.

Storage:

"Finnfoam" boards are waterproof, so they do not require special protection from atmospheric precipitation. "Finnfoam" boards can be stored outside, but if stored for more than three months, they should be protected from direct UV radiation. It is prohibited to store "Finnfoam" boards near fire or hot surfaces.

Packaging:

The boards are packaged in environmentally friendly packaging, using as little packaging material as possible (PE film). The packages are stacked on top of each other, making them easy to unload by hand or forklift.