Mini Rekuperators Vents Twinfresh Comfo Ra1-85-2 V.3 Sienas

Night mode

The integrated light sensor sends a signal to switch the ventilator to low speed mode.

Speed switching

Passive air supply

In this mode the shutters are open, but the fan does not operate.

Air supply

In this mode all ventilators will operate in supply mode irrespective of the maximum air supply setting.

Ventilation

All the ventilators in the network operate in permanent air extract or air supply mode. To ensure balanced ventilation at the stage of installation it is advisable to set one half of the ventilators to air supply mode and the other part of the ventilators to air extract mode.

Ventilation with heat recovery

Humidity control mode selection

The ventilators can be connected into one network for centralized control. The signals from the control panel and the remote control, as well as from the humidity sensor, are received only by the master (main) ventilator

• Maximum ease of installation – mount into the wall, plug in and use.
• Normal operation of the unit at temperatures down to -20 °C (-30 °C with a hood for a cold climate).
• Built-in humidity sensor for automation of unit operation.
• Connecting a large number of units to the network using control cables.
• Control via remote control or buttons on the unit casing.
• Automatic blocking off draughts by means of louver shutters when the unit is switched off.
• Noise from 13 to 34 dBA.
• Ventilation of premises with the area of about 40 m2 (the area is approximate and depends on the ventilation standards in your country). Higher degree of supply air purification can be achieved with an F7 filter.
• Electrical fuse on the board for increased electrical safety.